The Sync Control is located on the left side of the Brake Control Unit, forward of the mounting bracket. The Sync Control adjusts trailer brake aggressiveness. The trailer brakes become more aggressive as the switch is moved toward the front of the tow vehicle. To view the Sync setting on the display, press the brake. The display will change to the Sync mode.
The Sync setting is shown as 1. The Sync adjustment has no effect on the manual control. The Sync Control would be adjusted for individual driver preference or changing road conditions. The Manual Control only applies the trailer brakes and would be used during initial setup and in situations where it is desirable to reduce speed slowly.
When the Manual Control is pushed to the left, the control begins to apply the trailer brakes. The further to the left it is pushed the harder the brakes are applied until the maximum set by the Output Control is reached. The Output setting will be shown on the display and can be adjusted when using the Manual Control. The Manual Control activates the tow vehicle and trailer stop- lights.
Preliminary Adjustments. With the trailer connected press and hold the brake pedal, the Display will show the Output setting. Adjust to 2. While still holding the brake pedal move the Sync Control slightly, the Display will change to the Sync setting. Adjust to 4. In an open area, such as a large parking lot, drive forward and apply the trailer brakes using the Manual Control.
If the trailer brakes are weak adjust the Output Control up. If the trailer brakes jerk or lockup adjust the Output Control down. Repeat this step until firm braking is felt with out jerking or lockup. Once the Output is set, drive forward and press the brake pedal, the tow vehicle and trailer should make a smooth stop. Your email address will not be published.
Write to me in PM, we will communicate. In my opinion you are not right. I am assured. I can prove it. Write to me in PM, we will talk. I think, that you are mistaken.
I can defend the position. Write to me in PM. I think, that you commit an error. Write to me in PM, we will discuss.
0コメント